MasterRoc FLC 100

MasterRoc FLC 100

100 EGP 100

MasterRoc® FLC 100 A powdered admixture for the production of non-shrink, high strength grouts for post-tensioned cables and fixing anchors or bolts in concrete or rock DESCRIPTION AND PROPERTIES Mast...

Price 100 EGP
Stock Availability available
Rating (4 / 5)


MasterRoc® FLC 100 A powdered admixture for the production of non-shrink, high strength grouts for post-tensioned cables and fixing anchors or bolts in concrete or rock DESCRIPTION AND PROPERTIES MasterRoc FLC 100 is a chloride free admixture in powder form. It is added at the rate of 6% by weight of cement to produce a flowable, pumpable, nonshrink non-segregating, impermeable grout, providing high strength and high bond to steel. The most important property MasterRoc FLC 100 imparts to grout is the ability to protect cables against corrosion from aggressive agents and stress. Inadequate protection against corrosion offered by normal grouts is due to: a) Excessive capillary microporosity due to high water/cement ratio. Using MasterRoc FLC 100 the water/cement ratio is reduced to 0.3; b) High macroporosity caused by bleed water collecting under strands and in the upper part of the sheath (Fig. 1). When bleed water evaporates and is reabsorbed by the cement paste, voids form thus providing easy access for corrosive substances. European recommendations on prestressed concrete (FIP) prescribe that the volume of bleed water must not exceed 0.5%. With the use of MasterRoc FLC 100, the volume of bleed water is considerably lower: it ranges from 0 to a maximum of 0.3% as per BS EN 445 – 2007 and dependent upon the type and quality of the cement used; c) Shrinkage of cement paste and consequent cracking. With normal cement grouts final shrinkage varies from 2 to 3mm. MasterRoc FLC 100 allows not only shrinkage to be eliminated completely, but also slight expansion to occur during setting and hardening. The main properties of grouts containing 6% of MasterRoc FLC 100, shown in Tables 1 and 2, can be summed up as follows:  Very high flowability (as measured by the Flow Cone Test) without bleed water or with a very low amount of it. The pumpability of the grout is assured for at least two hours at + 20°C.  High mix water retention. This very important property imparts high cohesion to the very flowable mix. Under vacuum, of 600mm Hg, over 90% of the water is retained by the MasterRoc FLC 100. Inadequate water retention would allow water to separate from solid components when the grout is forced through strands of tendons.

  1. There is no reviews yet.